Transmission line probes are a special type of passive probe designed for use at very high frequencies. They replace the high impedance probe cable found in a traditional passive probe with a precision transmission line, with a characteristic impedance that matches the oscilloscope input (50 Ohm). This greatly reduces the input capacitance to a fraction of a picofarad, minimizing the loading of high frequency signals. A matching network at the tip increases the DC input resistance. While they have lower DC input resistance than a traditional passive probe (usually 500 Ohm) to 1kOhm), the input impedance of these probes remains nearly constant over their entire frequency range. A traditional /10 passive probe will have a 10 MOhm) input impedance at DC, however this impedance drops rapidly with frequency, passing below the input impedance of a transmission line probe at less than 100 MHz.

With the ProBus interface, the ZD500, 1000, and 1500 becomes an integral part of the oscilloscope. All probe gain and offset controls are transparent to the user, making it easier to probe the circuit without concern for which gain setting to choose. When used with a LeCroy digital oscilloscope, no external power supply is required.

• Image acquisition from Camera Link Base camera 
• Supports Camera Link® operations up to 85MHz 
• Supports 32/64-bit Windows platforms 
• Quarter-length PCI Express x1 Board 
• Power Over Camera Link® (PoCL) Compliant 
• Offers external acquisition control signals on single PCIe x1 slotROHS compliant

• High resolution global shutter CMOS sensor 
• 3 resolution models – 2M, 3M and 5M 
• Dual core 1.5 GHz processor 
• Embedded application software 
• Ease-to-use setup for new vision adopters 
• Built-in vision capabilities for most applications 
• Standard factory protocols (EthernetIP, Modbus, Profinet) 
• Operator interface flexibility 
• Gigabit Ethernet and RS232 communications 
• Isolated I/O and direct lamp connections 
• Integrated ring light (optional on 2M version only) 
• IP67 enclosure with lens cap 
• Convenient mounting options 
• Standard M12 cables

Probe adapters provide simple and easy interface of third-party probes as well as change between the different Teledyne LeCroy Oscilloscope input and cable types (ProBus, ProLink, K/2.92 mm, BNC and SMA). Depending on the adapters, changing between the Teledyne LeCroy Oscilloscope's input type may have an effect on the overall performance of the channel.

With the ProBus interface, the ZD200 becomes an integral part of the oscilloscope. The probe sensitivity and offset are automatically optimized based on the oscilloscope gain settings, so control is transparent to the user. When used with a LeCroy digital oscilloscope, no external power supply is required.

• 5 GigE Ethernet port & hardware
• Supports cable lengths up to 100 m (CAT-5e, CAT-6) or (4T-6A)
• Simplified set-up with field proven Sapera LT software featuring CamExpert
• Engineered to accommodate industrial environment with a ruggedized screw mount RJ-45 connector