• Allows TekProbe interface level II probes to work with any ProBus-equipped Teledyne LeCroy oscilloscope 
• Automatic probe detection 
• Provides all necessary power and offset control to the attached probe 
• Supports probes up to 4 GHz 
• Easy firmware updates 
• Wide variety of probes supported including: Preamplifiers, Current Probes, Single-Ended Active Probes and Differential Active Probes

With the ProBus interface, the ZD500, 1000, and 1500 becomes an integral part of the oscilloscope. All probe gain and offset controls are transparent to the user, making it easier to probe the circuit without concern for which gain setting to choose. When used with a LeCroy digital oscilloscope, no external power supply is required.

• 2, 4 and 8 channel configurations 
• 16-bit vertical resolution 
• Sample Rate up to 12,32 GS/s with RF mode 
• 16-bit vertical resolution. 
• 4 GSample waveform memory per channel 
• Up to 5 Vpp Output Voltage and ±2.5 V Baseline Offset (into 50?)

With the ProBus interface, the ZD500, 1000, and 1500 becomes an integral part of the oscilloscope. All probe gain and offset controls are transparent to the user, making it easier to probe the circuit without concern for which gain setting to choose. When used with a LeCroy digital oscilloscope, no external power supply is required.

• Up to 20 GHz bandwidth and 80 GS/s sample rate 
• The most advanced oscilloscope user interface 
• The industry’s only true hardware 14.1 Gb/s serial trigger 
• Low Jitter Measurement Floor and exceptional timebase stability 
• Comprehensive set of serial data analysis, debug, validation and compliance tools 
• Integrated 50 Ω and 1 MΩ inputs for true connection and probing flexibility 
• Integrated standard and custom measurements and math functions for unrivaled analysis capability 
• Multi-lane serial data eye, jitter and crosstalk analysis 
• Real-time de-embedding, emulation, and equalization

Transmission line probes are a special type of passive probe designed for use at very high frequencies. They replace the high impedance probe cable found in a traditional passive probe with a precision transmission line, with a characteristic impedance that matches the oscilloscope input (50 Ohm). This greatly reduces the input capacitance to a fraction of a picofarad, minimizing the loading of high frequency signals. A matching network at the tip increases the DC input resistance. While they have lower DC input resistance than a traditional passive probe (usually 500 Ohm) to 1kOhm), the input impedance of these probes remains nearly constant over their entire frequency range. A traditional /10 passive probe will have a 10 MOhm) input impedance at DC, however this impedance drops rapidly with frequency, passing below the input impedance of a transmission line probe at less than 100 MHz.

• High signal fidelity to 4 GHz bandwidth 
• Low circuit loading – High input impedance and low capacitance 
• 4 GHz, 2.5 GHz, 1.5 GHz and 1 GHz models 
• 1 MΩ input resistance 
• 0.6 pF (4 GHz) and 0.9 pF input capacitance 
• ± 8 V input dynamic range, ± 12 V offset range 
• Wide variety of tips and grounds 
• Easy to use, integrated with oscilloscope