Benefits 

• You can test components that can’t be probed, such as BGA and fine-pitch devices 
• Works within minutes of connecting to your board 
• Allows you to increase yields by quickly debugging and verifying manufacturing faults 
• Reduce time to market by shortening the window from prototype to manufacture 
• Save money by removing the need to have multiple download tools for programming devices

Control and monitor the pins on JTAG devices 

Pin values can be set high or low, or into slow or fast toggle in real time, all at a click of the mouse. The values are then displayed by colour-coding the pins. Pins can also be colour-coded by various properties, such as input/output. 

Monitor the values and properties of all the pins on your JTAG-enabled devices, even BGAs, in real time.

Device programming 

XJAnalyser can run SVF and STAPL / JAM files that apply to any sequence of devices on a board. Any headers and trailers are set up automatically.

Golden board comparison 

XJAnalyser can capture the values being driven onto the JTAG devices of a known good working board. These values can then be used to identify differences between boards exhibiting unexpected behaviour and a known good reference board.

JTAG Chain Debugging 

XJAnalyser can be used to help with debugging of the JTAG chain, by giving feedback on the number of devices it can detect as well as the ID codes of those devices. See here for more information.

Pin Watch 

You can select pins and place them in a watch window to separate their changes from all of the pins around them on a device. 

The Pin Watch can also be used to build a bus from a number of pins; you can then write a value to the bus to set all of those pins at once.

Zoom In / Split Screen 

XJAnalyser gives you the flexibility to see the circuit as a whole or close up, with user-definable zoom levels. You can also split the screen and view different parts of the circuit at different magnifications.

Run chains / Single Step 

XJAnalyser can either perform continuous write-read JTAG cycles, giving instant feedback on signal changes, or it can iterate single cycles under user control, allowing manual changes between each cycle.

Alter Device Geometry 

If the device geometry is incorrectly specified, or not specified, in the BSDL file, you can change the number of pins on each side to reflect the actual geometry of the device. There is also an option to rotate devices.

Waveform Viewer 

The Waveform Viewer captures and displays the digital signal levels and transitions of JTAG chain data. 

It supports triggering, allowing circuit behaviour to be captured under specified conditions, such as when particular events occur. This can greatly improve an engineering team’s ability to capture key information and track down intermittent faults.

“Plug-and-Play” configuration 

When the machine running XJAnalyser is connected to a circuit, it automatically investigates the JTAG chain and identifies the correct BSDL files from its library, ready to run tests.

Recommended system requirements 

• Intel® Core i3, i5, i7 processor or equivalent (any generation) 
• Microsoft® Windows® 8, Windows 8.1, Windows 10 1607 and later, or Windows 11 (32 or 64 bit) 
• 4 GB of RAM