eZ Processing is the solution for telemetry data processing, analysis and display (real time or playback). It allows the capture of the data either from a PCM signal or directly through data sent on Ethernet (IRIG 106 Chapter 10) by the receiver.

It performs the frame synchronization, Engineering Unit conversion, data display and storage, as well as data subset dissemination to dedicated analysis tools. It can accommodate multiple display stations, each having selectable parameters and displays. When used in a system with Safran Defense & Space, Inc. (formerly Safran Data Systems, Inc.) data acquisition units like the XMA or MDR, the software parameter database is automatically updated by eZ configuration software, reducing the set-up time and preventing all errors.

• Direct PC bus access data acquisition system provides the required sampling rate and resolution to meet IEC 61000-4-7 measurement requirements and supports high-speed data transfers. 
• PC-based Harmonic and Flicker test software provides real-time full-color data display updates and continuous PASS/FAIL monitoring. 
• Automatic calculation of the maximum permissible system impedance Zsys, using the Zref and measured Flicker parameters, as required per EN/IEC 61000-3-11. 
• Intuitive operating software provides IEC test setup, data analysis, display, with test reports in and MS Word format. 
• High resolution, no gap acquisition data storage to ensure that all data can be streamed to disk (in ASCII format if needed) for later review and replay of the actual test. 
• Single Step and Fast playback mode of test results.

• Facilitate computer integration with a PCIe® x1 interface 
• Benefit from real-time synchronization with 16 discrete digital I/Os 
• Get straightforward access to I/Os via standard D-Sub connector 
• Support factory-floor and lab use with 24 V and TTL-compatible signaling 
• Protect against unintended use with optical isolation and resettable fuses 
• Track moving production lines with support for two rotary incremental encoders 
• Use status indicator LED for each I/O to assist with integration troubleshooting 
• Leverage Gigabit Ethernet port for industrial communication or video capture using GigE Vision 
• Use with Zebra Aurora Design Assistant (formerly Matrox Design Assistant) and Zebra Aurora Imaging Library (formerly Matrox Imaging Library), vision software

• Repair-focused environment for XJDeveloper / XJRunner tests. 
• Full Connection test. 
• RAM, Flash and other non-JTAG device tests. 
• Flash, FPGA, CPLD and EEPROM programming. 
• Layout Viewer* to show the physical location of faulty nets, pins and components. 
• Schematic Viewer* to show the circuit design around faults. 
• Direct control of the pins/balls of JTAG devices. 
• View pin states graphically in real time or capture them in the Waveform Viewer. 
• Trace signals to identify shorts, opens and other faults.