Test & Measurement
Download Line Card
Document
Products
The EX1200-7008 is a Multichannel Glitch-free Universal RTD Simulator with eight channels and universal, 2-/4-wire RTD simulator
Signal Generations, Arbitrary Waveform generation and Digital to Analog output modules for providing signal simulation capability
High density switch matrix models in 1 wire and 2 wire configurations
-
8 frequency counter channels, 16 isolated digital I/O channels, 2 isolated DAC channels in a single card
-
Single frequency measurement range that works from 0.05 Hz to 1 MHz
-
Very stable TCXO base clock, 50 MHz ±1 ppm
-
195 kΩ Input impedance with selectable coupling (AC/DC)
-
Wide differential input voltage range (±48 V) with up to 250 V working common mode voltage
-
Programmable threshold and hysteresis levels with 1 mV resolution
-
Support for quadrature encoder
-
Isolated DIO channels with up to 60 V compliance
-
Isolated and independent 16-bit DAC channels, configurable for voltage or current output
-
Up to 96 differential channels per full rack mainframe
-
Constantly monitor input signals for fault conditions
-
Flexible configurations for detecting edges, out-of-bounds conditions and measuring pulse widths
-
Inputs can be masked, inverted, and combined to produce interrupts
-
Can be used as a time stamp module and as a digital I/O
-
Programmable debounce circuitry prevents erroneous readings
-
10 V and 100 V input ranges
-
On-board memory stores events with IEEE 1588 timestamps
-
Synchronize reading of input states with other scanned analog channels
-
Eight ports of 8 I/O bits each
-
High current capability for control of external relays, 300 mA sink
-
Simulate and receive digital data at up to 2 MHz sample rates
-
Selectable output voltages range from 3.3 V to 60 V
-
Setup outputs and scan inputs as part of EX1200 measurement sequencing engine
-
16 integrated analog backplane lines
-
4-slot carrier plugs into a standard EX1208A series mainframe
-
Configure with either Resource or I/O matrix modules in any combination
-
1 or 2 pole switching options, up to 300 V/2 A
-
Typical bandwidths in excess of 20 MHz
-
Integrate with optional 6.5 Digit DMM across backplane
-
Up to 176 x 8 2-wire configuration in 4-slots, 704 x 8 in a single 3u mainframe
-
Pre-program hardware triggers to automate relay states and reduce cycle time
-
Typical accuracies of ±0.20°C
-
16-channel isolated universalt hermocouple/voltage inputs
-
Power over Ethernet+ (PoE+)
-
20K samples/second/channel sample rate
-
24-bit ADC per channel
-
500 V channel-ground isolation
-
1000 V channel-channel isolation
-
Data logger acquisition mode
-
Built-in parallel data streaming
-
Full-featured embedded web interface
-
LXI Ethernet interface
-
8-bit bank isolated digital I/O
-
Compact 1U half-rack form factor