AR Microwave horns take microwave coverage to a new level. Our broadband RF and microwave horn antennas are specially designed to compensate for the losses that typically occur in test systems as frequency increases. They exhibit increasing gain with increasing frequency, up to 50 GHz. AR microwave horn antennas can be used in shielded rooms or in free space.

When test needs call for higher power and higher frequency, consider our “T” Series microwave amplifier line– 1 to 50 GHz, 40 to 20,000 W CW and Pulse. These amplifiers provide coverage for a wider range of high-power microwave test applications than any other brand of microwave amplifier on the market and are incredibly feature-rich. 

They also offer an advanced design and highest quality construction of any TWT amplifier on the market.

Our “A” and “W” Series amplifiers have the power to deliver all the field strength you need. With unsurpassed mismatch capabilities and excellent flatness, they provide all the power promised over the entire operating band. 

We subject our amplifiers to the harshest conditions just to make sure they give you reliable service and performance over the long haul. We test them under various output VSWR loads to stress them to the limit. The only problem we ran into was that there were no available loads to handle the enormous power up to 80,000 W that our amplifiers deliver. Whereas this would stop most manufacturers, it presented another challenge to our talented designers, and we designed our own. All our RF solid-state amplifiers have modulation capability that will faithfully reproduce AM, FM or Pulse Modulation appearing on the input signal for use in the most demanding EMC applications. 

These technologically advanced amplifiers perform beyond the norm, beyond expectations, and way beyond the abilities of other test amplifiers. 

These self-contained, broadband, completely solid-state amplifiers are designed for applications requiring the ultimate in output power over a wide instantaneous bandwidth with high gain. Extensive control and status reporting capabilities are available both locally and remotely. Most models feature air-cooled designs while some higher power units feature liquid cooled designs. The touch-screen panels are intuitive, convenient, and easy to use.

• Allows TekProbe interface level II probes to work with any ProBus-equipped Teledyne LeCroy oscilloscope 
• Automatic probe detection 
• Provides all necessary power and offset control to the attached probe 
• Supports probes up to 4 GHz 
• Easy firmware updates 
• Wide variety of probes supported including: Preamplifiers, Current Probes, Single-Ended Active Probes and Differential Active Probes

AR E-field generators offer exceptional uniformity between the elements. Our ATE10K30M uses low inductance high-power internal load resistors to terminate RF power, and offers well-matched input VSWR. The ATE10K100M is our own patent-pending folded-dipole type design. And we haven’t yet found a test object the ATE10K25M–1 can’t handle.