1.85 mm (V) DC to 67 GHz connectors from Southwest Microwave include field-replaceable 2- and 4-hole Flange-mount and standard or metric Thread-in Connectors, Direct-solder Cable Connectors, clamp-on End Launch Connectors, and the new Solderless Vertical Launch Connector.

• Measuring device to detect the twist/lay/pitch length of sheathed cables
• Measurements according to the standards LV212 und LV122
• The twist length of the sample is measured without removing the sheath → this ensures a precise measurement
• Traditional methods manipulate the sample (cable stripping or unwinding of conductors) → a precise measurement is not possible anymore
• Via a PC connection, the measuring results can directly be exported
• Fully automatic: By clicking one button, the measuring sensor automatically moves along the sample

• Calibration-grade metrology standards
• Used for VNA calibration and/or calibration validation

A precision fixed termination (or load) consists of an immovable, (fixed) termination which, when mated to the end of a trans-mission line or cable, absorbs nearly all of the signal energy traveling toward it. An ideal “matched” condition exists when a termination with an impedance value of Z0, is connected to the end of a transmission line or cable that also has a characteristic impedance of Z0. Such an ideal “matched” condition (one with no mismatch between the termination and its mated line or cable) is critical if a voltage standing wave ratio (VSWR) of 1.0:1 is to be achieved in a system with a 50 or 75 ohm impedance value. Simply put, the more closely the 1.0:1 ratio is approached, the more accurate the measurements that can be made from a system.

Quantity in Stock: 1