• 5 MHz or 10 MHz Outputs Available 
• Reference Frequency Input Option 
• Auto Changeover with Ref. Input Option 
• Low Phase Noise Outputs 
• Twenty four Outputs 
• Front Panel Status Indicators 
• Fault Discrete Inputs 
• Compact 1U, 19” rack mount

Systems are complete. They plug into an outlet and are ready to go. Our standard systems are 3U, which is 5.25″ and 5U, 8.75″. Systems are available with or without IEEE-488, RS-232 and Ethernet connectivity. Amplifiers Systems are available in both Broadband and Band-Specific frequencies. We are well-known in the industry for successfully adapting our amplifiers or custom designing new solutions to suit each unique project. Please refer to our Adapted & Custom Design Solutions link to begin formulating your performance objectives and other criteria.

• 96 digital lines configurable as either input or output 
• Five available power supply rails for custom designs 
• Mix and match with standard SMIP switching and digital I/O modules to create high density configurations 
• VXI plug&play driver simplifies software development 
• On-board connector header for simplified migration to PCB implementation 
• Access to 16 MHz clock for use in complex designs 
• Multiple front panel connector options

• Network Enabled Distribution Amplifier 
• Low Phase Noise Reference Frequency Outputs 
• Fault Alarm Output 
• 1U 19″ Rack Mount 
• Frequency Synthesizer Option 
• Hitless Switching of Reference 
• Programmable Amplitude 
• Propagation Delay Compensation 
• 10 MHz Standard, Other Frequencies Available

Signal Generations, Arbitrary Waveform generation and Digital to Analog output modules for providing signal simulation capability

High density switch matrix models in 1 wire and 2 wire configurations

• All Digital IF technology 
• 10.1” WVGA (1024 x 600) Display 
• Frequency range from 9 KHz up to 3.2 GHz 
• -161 dBm/Hz Displayed Average Noise Level (Typ) 
• -98 dBc/Hz @ 10 khz Offset Phase Noise (Typ) 
• Total Amplitude Accuracy < 0.7 dB 
• 1 Hz Minimum Resolution Bandwidth (RBW) 
• Comes with Preamplifier

• Tiny “all-in-one” solution: no external control board needed 
• Superior image quality: sub-micron lens movement with very low tilt. Now with higher dynamic stability 
• Low voltage & power: 3.3 VDC input, zero power position hold 
• Simple system integration: accepts high-level motion commands over standard serial interface (I2C or SPI) 
• Flexible, production-ready system: compatible with M8 to M16 lenses and with typical image formats from 1/3” to 1/1.8” 
• Lowest cost, fastest time to market: Fully-engineered “plug and play” solution